XL (65")

If you experience any issues, please contact support and we will do everything we can to fix it. We offer a 1 year warranty, and will either repair or replace any defective parts. Returns, however, are not accepted.

We ship anywhere in California for a flat rate of $250.

Instructions:

We will set the unit up upon delivery, however the setup and care instructions are as follows: Simply fill the waterproofed tub with water, place the temperature probe into the water, plug the thermostat cord into the GFCI extension outlet, then plug the freezer cord into the thermostat outlet. Type in your desired water temperature, and the thermostat will regulate the temperature by turning your freezer on or off automatically in order to keep the water at your target temperature range.

Next, place the filter pump on the floor of the plunge and plug into the GFCI, and let the filter circulate the water constantly.

Finally, place the o-zone hose into the water. Plug the o-zone cord into the timer, type in what time you want the o-zone to sanitize your water every night (i.e. at night, when you're around it or using it), and plug the timer into the third GFCI extension cord outlet. 

Filter Care:

Clean the mesh filter which resides inside the pump once a month. Remove the filter and rinse with water, then place it in a bucket of 5:1 water:bleach and let it sit overnight. Rinse again in the morning and put it back in the pump. If done consistently, this can be done many times before the filter needs to be replaced.

Use:

Unplug this GFCI cord before each plunge, and simply replug the cord back into the wall when you're finished with your ice bath. The cold plunge will continue to operate as intended.

Note:

It will first take 12-24 hours to get the water under 50 degrees, and then once there, the unit will only need to run for a few minutes each day to keep your water cold, and will now do so automatically. 

If possible, keep the plunge indoors. If not possible, keep a cover over the unit when you are not using it. If rain is expected, keep the freezer unit and any electrical outlets covered. 

Always unplug the GFCI cord before entering the cold plunge. Although the GFCI cord adds a measure of safety by cutting off any electric current in the event of a power surge, simply unplugging this one master cord ensures there is no electrical current flowing through the device while you are inside it. When you finish plunging, simply plug the GFCI cord back into the wall and the device will run again automatically.

Only operate the o-zone machine when nobody is around the cold plunge. O-zone is very efficient at sanitizing the water, but is not safe to inhale. This is why it is advisable to only run the o-zone when nobody is around the device such as in the middle of the night or when you are at work, and is then safe again shortly thereafter as the o-zone dissipates.